Ocie's Box - Enclosure for Duet Wifi Table Mount

thingiverse

Changed the Design of the full-sized model to something that fits better on the Ender 3 without sacrificing features. This was my first hack-and-slash attempt in Tinkercad, so I know it could be improved. Changes * Reduced length to just under 223mm. * Removed cable lugs and added six holes for 16mm aviation connectors. * Sealed remaining cable holes and added a hole for the 16-awg main power line. * Replaced USB and Mosfet board mounts with a pair of LM2596 buck converters. * Removed venting from the bottom of the case as it will mount flush with the table and added new side venting. * Reduced mounting screw hole size to 3mm and added a second set of legs for mounting. Added two lid options: one with vents and one without. This allows you to adjust the venting to suit your needs. I printed the base with supports, but they should not be necessary if you have good bridging and retraction settings. Update (1-24-2019): Lid printed and fits well. The small holes made the print take hours, but it works fine. Parts: * Aviation Connector 10-pin: https://www.amazon.com/gp/product/B01NCT2SCU/ * Aviation Connector 4-pin: https://www.amazon.com/gp/product/B07D7SHKGK/ * Wago 221: https://www.amazon.com/dp/B01M9C4DNO/ * Fan 40mm: https://www.amazon.com/gp/product/B071W93333/ * 3mm Brass Threaded Insert: https://www.amazon.com/dp/B01IYWTCWW/ New Wire Harnesses: * Stepper Motor Cables 100cm: https://www.amazon.com/gp/product/B07175F6P7/ * 24-awg Wire: https://www.amazon.com/gp/product/B07DCV7BDD/ * Cable Sleeve: https://www.amazon.com/gp/product/B07FTT6WXD/ I wired up the 10-pin connectors: 1. Extruder, x-axis, and x-stop. 2. Z-axis, y-axis, and y-stop. 3. Bl-touch, hotend fan, and part fan. Cable harnesses for pins 1-3 are swap-able. I wired up the 4-pin connectors: 4/5/6: 24v heater and temperature control. Cable harnesses for pins 4 are all swap-able.