NZXT H1 Fan Bracket

prusaprinters

<p>I wanted a bracket so I could mount fans in the back of my NZXT H1 case without them being visible while still being able to use the exiting back panel. Since I couldn't find anything quite what I wanted I designed my own.</p> <p>This should work for 140mm and 120mm fans, though I've only tested with 140mm fans, specifically Arctic P14 PWM PST fans. They are a bit on the chunky side so the bracket is 29mm deep to try and leave room. As can be seen from the pics I had to move the fan cover that's normally on the AIO cooler to the bottom P14 fan to keep the wires at bay (I replaced the stock AIO fan with one of the Arctic P14s).</p> <p>This part is broken into four pieces, largely because I do not have a printer than can print the entire part in one shot. If there is interest I can upload 2 piece and one piece versions, but since it's meant to print "on its back" it might be tricky to print it one shot. There is also the added upside that using the bolts/nuts allows for a bit of adjustment for fit if your printer tolerances are not as good.</p> <p><strong>Required parts:</strong><br/> 8 x M3x12<br/> 8 x M3 nuts</p> <h3> Print Settings</h3> <p><strong>Printer:</strong></p> <p>Artillery Genius</p> <p><p class="detail-setting rafts"><strong>Rafts: </strong> <div><p>No</p></div><strong>Supports:</strong></p> <p>No</p> <p><p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>0.2</p></div><strong>Infill:</strong></p> <p>15%</p> <p><strong>Filament:</strong> Inland PETG Black <br/> <p class="detail-setting notes"><strong>Notes: </strong> </p><div><p>I sliced these using an RC of PrusaSlicer 2.3.0 which has an adaptive infill that prioritize support structures. This printed faster than with other infills and still made for a strong print. YMMV.</p> When prototyping I used PLA before PETG but in the end I think PETG is a better bet if you have a warm system like I do (3080 FE runs hot).</div></p> </p></p> Category: Computer