Nux Mighty Lite BT Microphone Stand Mount

thingiverse

This print is a mount for the Nux Mighty Lite BT amplifier to mount it to a microphone stand. It also has a passive mixer so you can have a microphone and a guitar (or two guitars or two microphones) connected. Has a holder for smart phone to control the amp. (Optional). Has a holder for a USB power bank to power the amp. Has a holder for accessories (harmonics, capo, etc). Requires a microphone stand with an adjustment grip that is tapered on top (most are like this). Loosen the grip, remove the top part, feed top part through the square hole and reinsert top part. Move print so tapered top of grip goes into the hole (this prevents it from spinning). Holds amp at a nice height for standing or sitting. Amp can be rotated 360° to point in the desired direction. You will need (8) #4 x 5/8" tapered head screws to connect the pieces. If the "clean" channel is too quiet, use the "crunch" channel and set the volume to max and adjust with the gain setting. Parts for mixer: (1) Jameco 2272391 500K Linear Dual Pot (2) Jameco 691420 220K resistors (any 220K resistors will do) (3) Jameco 281738 1/4" Jacks Mono (any mono jacks will do). DO NOT SOLDER THE MIXER WIRES WITH THE PARTS MOUNTED TO THE PRINT. IT WILL MELT THE PRINT.