Nut - Front

thingiverse

Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=193647 Using the following options: Outer diameter: set to 14 Type of fastener: a nut Inner diameter: established at 8 Step shape angle for the threads in degrees: configured at 45 Distance between threads in the thread section: designated as 2 Non-threaded section length is set to 0 Thread pitch, which measures how much the screw turns to move a unit of measurement down the screw thread, in this context defined as 2 threads per inch (tpi) or every two units of measure on the circumference Wing height relative to its width: determined at 1 Layer resolution: selected at 0.5 mm Height of the nut body measured from base to crest (or tip), which includes any thread height beyond a solid body part, here configured at 20 mm Selecting exclusion for textured layer Diameter through which threads extend outside their normal area, denoted as outer thread diameter for external screws or bolts: this was specified with a value of 12. Shape and structure that is not hexagonal, described here as having 6 sides Width or distance through slot to start at a non-zero measurement (depth) Length by which to advance in slots before re-engagement begins again, identified here within this design choice with the numerical value two Head elevation measured vertically up from the main body base of this assembly item part number: set at five