Nusantara COVID-19 Face Shield Visor with Flip Cover and full head

thingiverse

I was heavily influenced by the HanochH design when creating this project. Several key changes were made: 1) The rear section was modified to ensure it stays in place without needing a rubber band to secure it. While one can still be used for added stability, it should fit comfortably around your head with or without. 2) The overall height of the design was reduced by 33% (10mm), enabling multiple prints to be stacked and speeding up print times. To use this design as intended, you'll need to insert an A4 clear transparency sheet into the head cover in landscape orientation. After that, simply close the cover to secure it. Print time varies depending on your printer and acceleration settings but can take around 1 hour and 15 minutes. If desired, consider printing two at once using the suggested orientation shown in one of the photos included with this design. Note: This is a print-in-place design, so make sure your printer is well-calibrated for optimal results.