Number pad (matching Royal Krudge RK71/Drevo Calibur V2)

thingiverse

Assembly hardware: (Non Keeb hardware runs you around 5 bucks at home depot) 5x M3 nut 2x m3-0.5 x 16mm socket cap screw (top end) 3x m3-0.5 x 8mm socket cap screws (lower end) Rubber feet (self adhesive 3/8" clear bumpers) Standard keeb stuff (Arduino pro micro, diodes,key caps, switches, wire) Season to taste. Put the bottom 3 screws and nuts in and tighten them first. The top 2 screw holes in the base plate are offset about 1mm from the keyplate/pro micro holder assembly, the key plate will flex enough to line up the m3 screws(although it takes a little elbow grease) this was done intentionally to flex the top plate and put a little more pressure on the key holes between stabilizers, as there was no easy way to get a tight fit on them given the flexibility of PLA.