Nuka Cola Pop Cover

thingiverse

So I downloaded the original Nuka Cola cap and absolutely loved it. Then I thought... I wish this fit over a can of pop. That's when I realized I could make it do just that! So I took the Nuka Cola cap and resized it to be roughly the size of the Can Cover by ElectronicKit. From there, I used Blender to basically shove the Can Cover inside the newly resized Nuka Cola Cap. When I did that, I had a Nuka Cola cap that fits pop cans perfectly! Note: This is a super tight fit at first. After a couple times popping it on and back off, it will fit snug. I printed with 200 on the hot end, 70 on the bed, and went with 100% infill. It can work with a lot less infill, but the difference between 20% and 100% was 10 minutes, so I figured why not!