Nude Female Torso Vase Mode

thingiverse

This is an EDIT of a previous version that was made for vase mode, but had features that were impossible to print in vase mode. I have uploaded two versions. One is 2mm longer than the other. The "safer" version starts slightly higher to hide the "anatomy". I have printed this, I used a .4mm nozzle but set my vase walls at .6mm for better overlap. There was still a little distortion at the shoulders, but you have to be picky to care. If I had set it at .8mm i'm sure it would have covered fine. The neck is another issue entirely, but there's not much you can do about that. it will look sloppy, but nobody is going to be looking at the neck. Some additional work could be done to make this perfect, but I just don't care enough to do the rest of the work.