Nucleo ST-Link Case and Connectors

thingiverse

This is a screw-together case for the ST-Link that comes bundled with any Nucleo 64 board. Two connectors are included, which serve as holders for jumper cables to prevent mis-wiring of the Nucleo board to the ST-Link. A different connector is required for each type of Nucleo board, and so far only one has been created for the STM32F303RE. The source code can be found in the hardware folder, which utilizes Solid Python as seen in swdconnector.py. Adding custom connectors is relatively straightforward. To assemble this case, four M3x16mm screws and hex nuts are needed to secure it together. Seven jumper wires per cable, or eight if you intend to power the Nucleo board from the ST-Link, are also required. A ribbon cable is recommended for a cleaner setup. The connectors must be printed with a resolution of 0.1mm. Print Settings: Printer: Prusa i3 Mk 2 Original Rafts: Doesn't Matter Supports: Yes Resolution: 0.2mm Infill: 10%