Nucleo 64 case with cover

prusaprinters

I needed some kind of protection for my nucleo board so I won't kill it with ESD. I tested it with the L452RE and L452RE-P (the variants with miniUSB and microUSB), but it should fit most if not all Nucleo-64 formats. You need M3x8 screws and nuts to secure the nucleo board - and I strongly advice to only use two screws (left and bottom one) - the design of arduino layout is dumb and the right screw will collide with GPIO header. Also, 2 screws are enough to hold it nicely. The case has two triangular slots in front and back, for the snap-fit cover - the GPIO headers stay accessible.The cover incorporates two buttons. Also 4 holes for mounting screws.   I printed with 0.3 layer, 3 perimeters, 4/3 top/bottom layers, 16% infill.