Nuclear bomb PC case. "Nuke"

cults3d

This text appears to be a set of instructions for assembling a custom computer case, specifically a bomb casing inspired design. Here are some key points summarized: **Printed Parts:** * Bottom01 (lowest part of bottom) * Bottom02 (center part of bottom) * Bottom03 (upper part of bottom) * Center01 (right side of center section with GPU mounts) * Center02 (left side of center section with power cable opening) * Center03-externalPSU (alternative left side with larger power cable opening) * Fin01 (fins on the bottom) * PSUclamp01 (clamps for holding SFX PSU to left center section, print two) * Tab01 (mounting tabs between center and top/bottom sections, print twelve) * Top01 (bottom part of top) * Top02 (top half of top) * Top03 (aerodynamic splitter cone for gluing to bottom of Top02) **Assembly:** 1. Glue Bottom01 and Bottom02 together. 2. Fit Fin01 parts together without glue. 3. Glue Top03 to the bottom of Top02 and Top02 to Top01. 4. Attach Tab01 pieces to slots inside Top01 and Bottom03. **Component Installation:** 1. Route GPU PCIe extension cable around the motherboard or edge, depending on preference (350mm B-type cable recommended). 2. Mount GPU at a slight angle using printed mounting points. 3. Insulate between GPU and motherboard with fiberglass, teflon, or cardboard. 4. Test fit motherboard before installing GPU. **Additional Tips:** * Paint fins separately. * Use super glue/CA glue for attaching tabs. * Use M6x8mm screws to hold center section parts to tabs. * Route HDMI/displayport cables out the back using 90° adapters if necessary. * Consider using fan management software to keep fans quiet when not needed. This text provides a detailed guide for assembling and customizing a unique computer case design.