NSX Center Armrest Cup Holder + Phone Cradle

thingiverse

Don't have access to a printer? I can print this for you at my store: https://etsy.me/2KhmI5a This fits NSX's with the original center armrests with one door. (not split doors) There are 3 pieces to print: * Cup Holder * Two sizes to choose from: 75mm or 84mm. 75mm is a little bigger than a can of soda. * Qi holder * Phone cradle/holder * Two sizes are available, iPhone XS and XS Max. When in doubt, choose the Max, it's the largest you can get. This leaves about 2" of space below for you to hold misc things (air fresheners, paper, etc). Specifically made to work with this Aukey Qi charger https://amzn.to/2Hj7v1o but any Qi charger that is smaller than 91x91x11.5mm will work. Print this in PETG or ABS if you leave your car in the sun. PLA would work if you don't intend to have our car sit in the sun for hours at a time. With supports: You can print the Qi holder and phone cradle as one piece and add supports for the overhangs. Without supports: print the qi holder and phone cradle separately and glue them together. Close the armrest cover 45 degrees and you'll be able to slide the tabs right under the opening of the lid and then down into the console. It's a tight/exact fit. There is a notch in the cup holders drivers-side-back-corner for a charging cable to be routed into the console. I had a Grom BT3/USB unit installed behind the drivers seat that I could use as power for the Qi charger.