NRF52840 USB Dongle Dock

prusaprinters

<ul><li>Use with P75-E2 pogo pins and a 1.6mm thick proto board</li><li>The pogo pins should protrude 1mm out of the bottom of the proto board.<br>&nbsp;</li></ul><p>Installation instructions:</p><ol><li>Place nrf_pogo_holder.stl over a proto build and insert all pogo pins</li><li>Fix the holder in place using hot glue.</li><li>Place the nrf_alignment_placeholder.stl on top of the pins and temporarily fix it in place with tape or hot glue.</li><li>Flip the board over (be careful as the pins may fly out). You should preparably do the assembly on a second flat surface which you can flip along with the board.</li><li>Solder the pogo pins in place.</li><li>Remove the alignment placeholder</li><li>Insert an NRF52840 dongle and fit it in place by sliding on an nrf_brace.stl piece from either side.</li></ol>