NR600 Reset Switch to Type C Port Conversion

thingiverse

A bracket to mod a Type C port into the Cooler Master NR600 case. This will replace the reset switch, which I don't use - and you can hold the power button if you need to reset.I used this type c cable - https://www.aliexpress.com/item/1005005397681858.html?spm=a2g0o.order_list.order_list_main.12.37f61802OZI8CV30cm worked for me (MSI x670-p), but didn't leave much slack, so depending on where the port is on your motherboard, you may need a longer cable (50cm lengths are available on aliexpress).This mod requires cutting down the cable, therefore the bracket will need to be modded to suit, so I have included the f3d file.To remove the switch bracket there are 4 screws - one on the front of the case, one into the top of the case and two into the side of the case.Once remove, remove the reset switch and you will need to cut down the switch clips so the inside of the cavity is completely flat. I've attached a photo but it is hard to see.On the type c cable, cut down the wings and also the plastic around the plug shaft. This is where you will need to modify the model to suit.Complete a test fit and once you are happy with how it sits and looks, glue the cable head to the printed bracket. One thing to be aware of is that the end that plugs into the motherboard is not bi-directional, so check which orientation it will sit in to reduce bends and help with cable management. I used a 5-min epoxy to hold the plug to the bracket - take care not to fowl the plug with glue.After this you can mount the printed bracket and cable to the housing - it will be held in place with a screw. Due to the thickness of the bracket, I used a longer screw (8-10mm from memory). I'm not sure what thread the screw is - I was lucky enough to find the right screw in my parts box - if anyone knows, please comment so I can add the info here.