NR200 & NR200P Vertical Stand (Updated)

thingiverse

Update : (June 3rd 2021) Created multiple versions of the stand-------- NR200 Angled (CM LOGO) -- Original with CM logo outline sticking out NR200 Angled -- Original with no CM logo NR200P Stand -- Revised model 300mm x 203.5mm x 50mm, clean look NR200P Stand 12mm PWR -- Same as Revised model but with 12mm standard momentary switch input slot NR200P Stand 16mm PWR -- Same as Revised model but with 16mm standard momentary switch input slot NR200P IO Stand -- Same as revised model but with a custom panel to screw the case front IO into. this will be difficult to get 100 percent accurate but should be good enough for now until I can test it my self Information: Designed this Vertical stand with the intention of getting it printed. It was created for the weirdos that enjoy the look of the NR200 placed in a upright vertical position like me haha. This 3D (angled) model is currently 236mm W x 324mm L x 50mm H This is strictly a base model as I do intend to finish this at a later date with changes made to include holes for both USB inputs and/ or power buttons but for now I'm sure others can make their own iterations and I'm sure people will find a way to print this on the smaller 3d printers as well. This stand also features a slot on the inside that allows for a phanteks m series RGB light strip with small gaps to allow the light to shine through. It has a 60mm wide gap at the rear as well to allow cables to feed out from and an indent on the top to hopefully make the pc case flush with the top surface. Disclaimer : This has not been tested or printed so I don't even know if this can withstand the weight of a full rig or anything for that matter. Please print at your own risk