NP300 Speaker Adaptors

thingiverse

This is my first 3d project, I hope I've met the communities expectations. I would prefer to upload editable exports from Fusion360 or Sketchup but I don't see a way to do that. I've created these models to suit my 2017 Nissan Navara D23 NP300 and the Kicker KSS650 speakers I've purchased for the front and rear doors. Mounting holes for the woofers are 123mm, tweeter in dash is: 42.6mm 30% infill seems fine. If you're in a warm climate, avoid standard PLA (it'll soften around 60degC)... consider printing in PETG or ABS FRONT DOORS: Upside down might be faster, this will significantly reduce the print time for the support structure. DASH TWEETERS: Tweeter adaptor was created "upside down", the protusion is only there for strength (and is probably overkill), the 'lump' should be put face down into the dash so the tweeter fits under the grill. REAR DOORS: The mounting holes are 123mm and I've reduced the height of the Front/Rear Doors by 9.5mm (from memory) for the speakers.