Nozzle Probe Guide

prusaprinters

<p>Did you ever have trouble getting a wire to go into the end of the nozzle? This makes it easy with a funnel on both ends. Top funnel lines up nozzle and bottom funnel makes a big target to guide the tiny wire into the tip of the nozzle.</p> <p>This would be better if it could be made of metal but I'm lazy.</p> <p>-NPG_01 has a 1mm dia hole but it tends to shrink a lot when printed. If the 0.4mm probe won't go through you can either drill it out with a #78 drillbit or you can push a heated pin through the blockage.</p> <p>January 15:</p> <p>-NPG_02 has a 1.2mm dia hole which may also be too tight but it should be easier to push a pin through.</p> <p>Jan 28:</p> <p>-Found a mistake in my drawing and corrected it. Also moved handle to the bottom of the tool so that it could be printed vertically to get a rounder interior. No support needed.</p> <p>-Uploaded NPG_05</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Creality</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Ender 3 Pro</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>Doesn't Matter</p></div> <p><strong>Resolution:</strong></p> <p>0.2mm</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>100%</p></div> <p><strong>Filament:</strong> Solutech ABS White</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>Ideally this should be made of metal but if you can't do that use the highest melt point filament you've got. After the part is printed you might want to press a pin through the opening to make sure that no filament has oozed into the very small opening. Once the bore is clear it's ready to use.</p></div> </p></p></p> Category: 3D Printer Accessories