Nozzle Change Tool Holder

prusaprinters

<p>I like keeping the tools for my printer close to the printer, so I made this tool holder for holding three tools:</p><ol><li>A low-cost 2.5 Nm torque wrench for tightening the nozzle. &nbsp;There are loads of variants of this, but most seem to be a similar size. &nbsp;I've included an editable STEP file in case you want to change the size of the hole.</li><li>A “stubby” 17 mm spanner for holding the heater block (there's no need for a full length spanner at such low torques)</li><li>A 7 mm spanner for undoing the nozzle</li></ol><p>It's made in multiple pieces so doesn't need any supports. &nbsp;The pieces should be good tight fit together, so just print them all, then shove them together.</p>