Nova3D Bene4 Mono Drip bracket

prusaprinters

As I designed and printed a drip bracket before, I realized its shortcomings. Most if not all brackets is tilted in one direction only. I found that is not good enough, so I tilted this one in two axis. I also moved the center point, but could probably go a little more to the left side. Tall prints may not fit with the door closed, but so far I had better results with this design.I'm also Including the Fusion 360 design, but beware, I removed the old component from the timeline, so it may be a bit messy.Print at whatever you are happy with. Supports required, I print it with the angled section up.