Nova AC Delete Gauge Cluster

thingiverse

So I faced two challenges. First was the placement of my temp, oil, and volt gauges, which wasn't quite right for me. Second was the hole left by my mid-dash AC vent that was no longer needed and the vent parts were in poor condition. The solution came from incorporating my 3D printing hobby. I designed and printed a gauge cluster that fits perfectly into the AC vent hole. There are four components to this project: 1 - Top Lip, which uses two screw holes for fastening. This gives the gauge cluster a place to slide smoothly up into position. 2 - Gauge Cluster, featuring three holes, one for each gauge. I made them slightly oversized and loose on purpose. A little electrical tape around the gauge will help it fit snugly without falling out. 3 - Two clips, designed without screw holes so you can attach them in the best location based on your specific situation. They clip onto the lower dash edge securely. I didn't fully refine the design, assuming that if you work on your car, you have the skills to improvise and make it work. Good luck and have fun with this project!