Nothing but horse Dick

cults3d

Insert-able length is 8.3" (210 mm), head diameter 1.9" (47mm), shaft diameter 1.4" (38 mm), medial ring 1.8" (46mm), it also has a suction cup base. Mold volume 380ml Can be scaled or cut in your slicer program and glued together to any size you want mold has location for 6 10mm dowels. Each has a mold and the actual pecker itself depending on how you are going to mold them. can be scaled, cut and glued together to any size you want Use Platinum Cure Silicone, Shore Hardness 10 = firm, 5 = Medium (ish), 3 = soft. Smooth-On is a good source for a quick and dirty toy (will have flashing that needs to be cleaned up) you can use the 3d printed molds You could also sand and clear coat the mold halves, using Vaseline to seal the halves (note: silicone touching Vaseline will not set so make sure it doesn't squeeze into the mold cavity during assembly. So don't use too much in other words) Print with thick walls ex: 4 layers or more you can also just print the dick it self, sand it smooth, seal and make a mold the old fashion way, use this way for the best results. I recommend printing vertical if possible to get the resolution. also need some 5mm dowels to align the top but not 100% needed. pour the silicone to just bellow the surface then right at the end of the pot life smush the top on using pins (ex skewers) in the alignment hole and a weight to keep it from moving a good resource for silicone toy making: https://vimeo.com/candiru Have Fun!!