Notepad Sleeve

thingiverse

I carry a pad of paper at work, but it always gets torn and mangled in my pocket long before it is filled up. So this is an attempt to make a slim sleeve that will keep the pad from getting destroyed. This should fit any standard 3" x 5" top coil pad of paper. Printing: Orient with the opening up, and the long edge along the axis the table moves, if applicable. No supports are needed but you should turn on Experimental>Make overhangs printable in Cura. (For some reason I couldn't put a fillet in that one corner in FreeCAD.) Print with three walls and there will be barely any infill.