Not-So-Slimbox cut in half for smaller printers with a usb c out

thingiverse

This is the same model as Not-So-Slimbox only cut in half with a usb c port outlet. [This](https://www.aliexpress.com/item/1005005282250054.html?spm=a2g0o.order_list.order_list_main.41.1e4d1802o3SADt) is the usb M to F extender I used. The keycaps are the same as the original, just download whichever version you want from there. I used [GP2040-CE](https://gp2040-ce.info/#/) on a Waveshare RP2040-Zero, but any RP2040 board should work, the full support list and pinouts for each board are on their site. For gluing the two pieces together I sanded the two halves and used a bit of instant glue to align them, waited a bit and then put masking tape (make sure it's non porous) on the outer shell, put some clear epoxy in the middle and wait for however long until it's completely done hardening.