NOT a RacerX Twig ET5 Mutant 4 Pod

thingiverse

***Important Butt-hurt users from "Racer X FPV builders" Facebook group who DIDN'T agree with my remix need not download this*** RacerX doesn't want to release the STL files for the Twig ET5/Mutant 4 Pod (for propitiatory reasons). But I did noticed they released Insta360 version, I decided to reverse engineer away the Insta360 Go mount and filled in the gaps, A for effort right? This is "NOT" the original RacerX ET5/ Mutant 4 Pod ;) Updates: - Added taller fin to assist with crash flip in tall grass - Added a cut out for Dipole antenna - Added 2 notches to the camera opening for camera angle alignment (see below) Camera angle Alignment Due to inconstancies in camera manufacturing (eg: lens distortions and sensor alignment issues etc.) It is no longer good enough physically set your camera housing at 45 degrees to be guaranteed the exact FPV viewing angle, you should set it using a visual guide while looking through the FPV feed. 45 Degree camera alignment instructions: Put a toothpick above the 2 points, then via your FPV feed adjust your camera so the the toothpick runs directly across the middle of your feed, done! Note: The 2 points are offset down 0.5mm on the pod so that when placing the toothpick above them, the toothpick is the centre. Note2: the 45 Degree camera alignment notches are only applicable for cameras fixed to the inner camera mounting holes. Enjoy!