Nose cone beauty mod for Hi-Point 9mm rifle

prusaprinters

<p>This is a nose cone (barrel shroud) modification for the Hi-Point 995TS 9mm Luger pistol-caliber carbine rifle. &nbsp;It may fit the other Hi-Point rifle calibers, please comment if you find that it will. &nbsp;The front picatinny rail must be removed for this nose cone to fit over the end of the plastic body and barrel cover on the front of the rifle. &nbsp;See pictures for the exact configuration. &nbsp;Note that this is a cosmetic change and does not actually modify the length of barrel, cartridge handling, or firing mechanism of the firearm.</p><p>Note that the pictures are of a print with larger mounting holes that are too low, now there is a small hole on the bottom, and the side mounting holes are smaller and higher up on the fitting. &nbsp;Use one to three small screws to SECURELY fasten the shroud to the rifle. &nbsp;It WILL come loose if you don't fasten it well.</p><p>BEWARE that the part MUST NOT contact the barrel as the soft meltable 3D-printed plastic is not like the high-temperature tolerant plastic body of the rifle, and if it touches the metal rifle barrel, after a few shots will MELT, SMOKE, CATCH FIRE, and (worst of all) be STINKY, so attach it to the rifle securely and ensure adequate clearance. &nbsp;The gun barrel can be thousands of degrees, but 3D plastic is molten at a few hundred degrees, so keep them apart! &nbsp;Everybody OK!</p>