Northern Pike (RC Plane) Creality Ender 3 Cura Profile

thingiverse

My Cura Profile for the Ender 3 to print the wings of the Northern Pike 3d printed airplane. I couldn't get the one listed in the original to load on Cura 4.4 so I spent time working on my own. The Flow rate could go down a bit it's set to 105% and that gave be good consistent walls and inner supports. But 103% was acceptable, just felt a little too thin in spots for me. Also I am using a brim of 8mm which is a bit much, but it allows me to check my bed adhesion, so you can dial that down if you want, though I would definitely suggest using some brim.