Normandy SR-2

thingiverse

A fully reimagined version of the model created by Wundel, inspired by 00meat. This revised design includes multiple part variations: - No Fins: Separate parts without fins on the main hull for printing (original parts with fins are also included) - Small: A scaled-down version designed to be printed at a smaller than one-fifth of an inch scale - Holes: 5mm holes added for use at scales 1/350, 1/500, and 1/650 (parts without holes are also included) Note: Due to the limitations of 3D printing, the vanes between the Front Inner and Outer Wing Flaps have been omitted - instead, sheet styrene should be used to replicate these features. Scaling Information: - The base model is approximately thirteen inches long when assembled - 1/650 scale: ten inches, scaled to seventy-nine percent - 1/500 scale: thirteen inches, scaled to ninety-four point five percent (Recommended) - 1/350 scale: nineteen inches, scaled to one hundred sixty percent "Go out there and give them hell. You were born to do this." - Garrus Vakarian