Noctua Fan Adapter to CoolGuys duct

thingiverse

Adapter for 150mm x 150mm fan and duct end bracket with 82.7mm x 82.7mm screw holes My print was good enough, but could have been better..paused at the top of support and used marker to increase "separation" from support material...but...this caused the "plate" on the duct side (aka tube side in FreeCad model) to not "stick". Print was slowed to 30% to attempt to compensate... Probably would have been better to: 1- not use a marker to increase "separation" from support material 2- not chamfer/bevel the bottom edge of top plate 3- print in 2 parts and glue together So this is likely best as a basis for a better model Also note FreeCad model copies the sketches to extrude the body...not preferred since altering the plate geometries does not alter the extruded body geometry automatically. All files provided AS-IS!