No soldering fairy light 20 led holder

thingiverse

I'm Assembling a 20-Led Holder Without Soldering. I Printed Two Shells, with Only 10% Infill and Support on the Base. Two More Shells Were Also Printed, This Time with No Supports and Still Maintaining a 10% Infill on the Lid. To Keep the Lid Secure, I Used a Small Screw, While Another Small Screw Was Utilized to Secure the Project Through the Base, Which Can Be Glued If Preferred. The LEDs Can Be Secured Using Either Glue or a Hot Glue Gun, Depending on Your Preference. I Wrapped the Excess Cable Around the Middle Pillar for Organization and Neatness. If You Wish to Increase the Infill, You Can Definitely Do So. As Shown in the Picture, the Assembled Size Is Quite Compact.