No Nonsense Flashforge Creator Pro Tube Guide

cults3d

Looking for a simple, straightforward and highly effective FlashForge Pro Creator filament guide holder? You've got it right here. This uncomplicated replacement is robust, lets you position it however you like and won't get in the way when you need to remove the back panel of your printer. I printed with PETG at 0.2mm without any support. Other materials should work just fine too. Just set your slicer of choice to produce a strong part (top/bottom/shell layers, temperature, infill, etc). Before installing this part, make sure your filament tube fits snugly into it. If it's too loose or too tight, no worries - just gently heat the part with a hot air gun or hot water and push it until you get the perfect fit. To mount the part first remove the old holder and the 4 clips (unscrew the four screws, cut the zip ties and remove the 4 mounts). Then use Scotch outdoor or extreme 1" tape - this one http://a.co/iolbiS8 is an excellent product, by the way - apply it to the back of the part and attach it to the back of the printer at your preferred position. If needed, a clean removal is possible. Slowly pry the part out (e.g. using a 3D print removal tool) and clean up any leftovers with alcohol.