No Hole 0.030" Visor Bottom

prusaprinters

<p>This has been tested for fit on 0.030" thick visor for the Prusa Protective Face Shield. It has not however been tested for extended periods of time.</p> <p>The purpose of this design is to reduce print time of bottom piece and cut time of visor by removing the three holes on each.<br/> The print time for this piece went from 22 min to 16 min estimate on my machine.</p> <p>The piece has alternating positive features on the inside track to hold onto the visor with friction. I included the F3D file to allow modification for different plastic thicknesses.</p> <p>If you use this design, please verify it will survive a full use of the face shield without slipping off. I'm optimistic it will perform well.</p> <h3>Print instructions</h3><p>No supports<br/> 0.3 mm layer height</p>