No.8 washer

thingiverse

Instructions Using the following settings: Inner diameter is set to 8, countersinks are dialed up to 2, Slot depth has been increased to 2, non-thread length is set to 0, Type of part being made is a washer, thread length stands at 25 degrees, Step shape degree is set to 45, wing ratio is set at 1, nut diameter reaches 12 inches in circumference. Non-threaded part's outer diameter stands at 0 inches and head height reaches an impressive 5 inches in the sky, Standard nuts will be used instead of anything else normal as required, slot width expands out wide by a factor of 1. Drive type becomes socket, wall thickness is now exactly 2 millimeters all around for added strength, resolution stands proudly at point five degrees north of nothing more than one thousand nine hundred eighty eight degrees to a complete spin, any other kind of texture such as that used on fine silk will not be applied here since we're using no special stuff, so we'll just have the plain old ordinary surface like everybody else in the family! Head diameter comes up with an incredible thirteen inches while drive goes straight and round with five whole ones and the outer reaches to exactly sixteen complete turns or laps as we prefer. last but not least, nut resolution gets reset back down below zero point five millimeters all the way out again where we first began from at ground zero - now back on top with facetted faces in just six glorious slices.