Nixon The Mission charger stand

myminifactory

 This is a replacement stand/charger for Nixon the Mission smart watch as is hard/impossible to get a new charger for this devices (the company discontinued the product).  I consider this charger a little better than the original, as it support all the base of the watch. The original seem to tilt the watch and depends on the magnets alone to mantain a good contact.  Besides the 3d print you need: - USB  breakout board, im using "U3-206 SMT Type USB-C Female Socket Breakout Board " but you can use any board that you consider, or even adapt a cable to the pins.  - Magnets, i'm using 2 5.5mm magnets salvaged from damaged headphones.  - Pogo pins, i'm using 2mm Dia 6mm Height On the picture, top is negative, bottom pin is positive. A little soldering and glue and you should be finish with this charger stand.