Nivelador cama V1

thingiverse

This system solves height problems in my CR10S4 bed. It's a modular system that lets you put as many pieces together as needed. I use easy-to-get material. First we heat up the bed to about 50 degrees, line up the bed on all four sides, and decide how many pieces we need to print. Each printed piece gets a screw, washers, and joined to the saw blades. We put it at the bottom of the bed, see image. For the back part, it's important not to get too close to the edge because it will bump into the motor. Next, we'll be tightening each screw slowly and adjusting the external settings as well. With this system, the best printing area will be near where you're adjusting, so take that into account when printing. Material thinking about 6 pressure points, but can be less depending on individual needs. 4 saw blades of 300mm. 6 M4 screws 12 M4 washers This system complements the central wedge system, here link: https://www.thingiverse.com/thing:3079473