Nitecore MH20 Ninjaflex, TPU, Jacket

thingiverse

The main goal of this creation is to provide added protection. A flashlight will stay unscathed even when carried in a pocket with change or keys. If the flashlight is dropped during use, it will offer some defense against dents and scratches. This will keep your expensive flashlight looking new for years to come. Now that I have created a 3D replica of the flashlight, I might design more accessories for this flashlight if there are any requests for it. Design features: A three-piece design allows easy access to batteries and provides an open area for heat dissipation. Good protection is offered both inside and outside your holster as well as while in use. The soft material feels good in the hand. It fits like a glove. Access is available to the USB port. Note: I've printed and tested this sleeve on Ninjaflex material only. I have not tried it with TPU or other flexible materials. While it's relatively easy to put the sleeve on, it's much harder to take it off. I had to use a vice and pliers to remove it. As a last resort, you may want to cut the sleeve off. Disclaimer: I am not responsible for any damage you may cause to your flashlight during this procedure. Print settings: Printer brand: LulzBot Printer model: TAZ 4 Rafts: No rafts were used. Supports: None were required. Resolution: A resolution of 0.2mm was achieved. Infill density: An infill density of 96% was used.