Nissan Remote Alarm Button Disabler

prusaprinters

I've always had problems with the alarm button on car remotes accidentally getting pressed while they were in my pocket. Since my current car has a remote with tact switches, I can't just put a piece of tape over the contacts like I could with rubber membrane switches. Instead of permanently altering the circuit board to disable the tact switch, I made this tiny plastic shim that sits between the button and housing to prevent the button itself from moving.Tested on a 2020 Nissan Leaf, but probably works on other similar Nissan smart keys. To remove the button, use a small screwdriver on the inside of the front housing to undo the two silver clips that keep the button from falling out.Recommended print settings: 0.10mm layer height, External perimeters first, 100% infill