Nissan Magnetic Phone Holder

thingiverse

Loved the concept of magnetic phone holder. Changes from original 1) now utilizes nine (9) 8x4mm magnets. 2) Cover glides in instead of being glued 3) Made the cover even thinner where the magnets are, now it is a mere 0.2mm thick. I printed the cover's first three layers at 0.1mm so I could achieve two (2) layers at the thin part. Then I completed the rest of the layers on the cover at 0.2mm thickness. The main section was printed at 0.2mm. If your slicer cannot adjust layer heights mid-print, just print the entire cover at 0.1mm - it takes longer but yields superior results in the thin area. I highly recommend printing supports on the cover, but I overlooked this and still managed to get away with it successfully.