Nissan Leaf ZE1 MagSafe Charger Cover

thingiverse

Needed somewhere to put a MagSafe charger in my Leaf, so decided to use the storage space in the middle of the centre console. The contours of the print are such that I can put my 13 Pro Max in Apple clear case 'camera first' and the phone lays flat. I printed in TPU and haven't tested this with solid filament. Fitting instructions: 1. Remove 'gearstick' trim (it pulls up) 2. Remove the OEM rubber matt (its held in place by the trim piece you just removed) 3. Position your charger and this print and stick the charger down. I used VHB tape. I didn't stick this print down as it was a snug fit for me. 4. Do some wiring. I used an 'add-a-fuse' adaptor in the fusebox on the passenger side of the cabin and ran a cable behind the glovebox to a 12v/cig lighter extension. Not sure if this is on the drivers side for LHD models? 5. Route the cable 6. Put the car back together.