Nissan Leaf Jack Block

thingiverse

This device enables you to utilize standard floor jacks equipped with circular pads as well as certain jack stands mounted on the leaf. The metal ridge found on the leaf's jack points is specifically designed to accommodate the trunk jack, but not more advanced and secure lifts. Note: This experiment serves as a model for evaluation purposes only. This prototype should be regarded as untested and potentially hazardous. Assuming this device will malfunction and cause catastrophic outcomes is prudent. Print Settings: Rafts: It does not matter (does not matter) Supports: Yes Resolution: 100 micron/layer Notes: Printing three layers on the side walls and two on the flat surfaces yielded adequate results, although supports were required for the bottom due to indentations created for the jacks.