Nissan 200SX S13 Wiper Pivot Mount

thingiverse

This 3D-printable item replaces the center plastic wiper pivot for Nissan 200SX S13 (possibly fitting an S14), as the original mount commonly fails over time, causing a squeaky wiper sound. The part is prone to breakage during wiper connecting rod fixes. ABS material is recommended, while PLA may warp due to higher car temperatures. To print and assemble: create one each of the mount and insert, gluing the latter into the bottom of the former (fitting without adjustments). Trim three M6 coach screws with 20mm threads, apply glue, and insert from the top; the design locks square heads to prevent turning. Remove the old plastic mount from your original part, clean rust off the pivot, grease it, and reassemble using the new mount. Finally, install back in the car for completion. The Sketchup source file is available for potential hex head bolt redesigns.