Nirvana NV-14 custom cover

thingiverse

This is a custom cover for the Nirvana-NV14 drone. I created this version because the stock one just wasn't cutting it. My design is easier to put on or take off, strong and looks nice in my opinion. Check out the YouTube video: https://www.youtube.com/watch?v=7prPJmUKDbg This cover can be printed with PLAX, PLA+, etc. Infill around 30% or more, layer thickness of 0.2mm, and wall thickness of 1.2mm are recommended settings. If you're using Cura, use the Roof/Floor setting for supports. I didn't optimize this model to minimize supports because I prioritized quality over print time and filament usage – about 50 grams were used in total. The two versions available differ visually; the Lite version is more open and looks better to me. A lot of time and filament went into perfecting this design, so any appreciation for a cup of coffee would be greatly appreciated. Note that this cover only snaps on when the strap is not attached. I made it this way because I remove the strap each time I take my drone flying. For the strap itself, check out: https://www.thingiverse.com/thing:3147830 I also created smoked gimbals for the Nirvana: https://www.thingiverse.com/thing:3196024 and a wall mount for the drone: https://www.thingiverse.com/thing:3487239 Update: I'm currently working on another version specifically designed for those who have their strap attached permanently – no ETA, but it's coming soon. Update 2 (v2): New versions of this cover are available with a small update to improve the fit. Additionally, there's now an option for those with a permanently attached strap – not fully tested yet, so any feedback is welcome.