Nintendo Switch Portable Charging Stand

thingiverse

Buy it on Etsy! https://www.etsy.com/listing/505538516/nintendo-switch-portable-folding-stand?ref=shop_home_active_1 Update: I tweaked the design slightly, making it taller. The Switch now sits about a half inch higher off the table than before, allowing for more room to prevent strain on the charging cable. I've also added a new center piece called Switch Stand Center Foldable. This piece features two hinges of different heights, enabling you to fold the arms inward. The center piece is slightly wider than the original, so the arms can fold completely within its width. This portable Zelda-themed charging stand solves a common issue with the Nintendo Switch. It offers: - A fold-flat design that fits into the same footprint as the Switch, making it easy to pack into your travel case. - A 60-degree angle provides an ideal viewing position. - Play your Switch while charging! The charging cable can be run through the front or out the back of the stand. - A wide base offers stability. - Simple three-piece assembly. Hinge pins are made from 1.75mm filament, which can be cut and slid through the hinge holes. The stand can also be disassembled by sliding the filament back out. Note: Cut the hinge pin filament at an angle to help it slide through the hinges. You may need a pair of pliers to feed it through. Print Settings: - Printer Brand: Wanhao - Printer: Wanhao Duplicator i3 V2 - Rafts: Doesn't Matter - Supports: No - Resolution: 0.2mm - Infill: 30% - Notes: I printed this at 0.2mm layer height and 30% infill. A brim is recommended to prevent corners from lifting during printing.