Nintendo Switch joy-con grip (now with a rework!)

thingiverse

Initial upload: This is a Joy-con grip for the Nintendo Switch' joy cons. I haven't printed it myself so I don't know if it will fit, so print at your own 'risk'!\nthere are two designs for the nintendo switch logo so you can choose which one you want to use.\nApril 18th: added reworks of the first two types, I wasn't happy with how the bit in the middle was connected to the sides.\nLater that same day: After some helpful commentary from Thingiverse user BlondeEskimo, I reworked them again, as BlondeEskimo told me that the overhang on the rail was too thick. I made the rail 0.3 mm slimmer, and I hope it will fit now. I'm sorry if you had printed this and it ended up as a failure!\nabout 1 year later:\nI'm happy to see the 2k downloads and 10k views! It's nice to see that so many people have decided they wanted to try out this design!\nThe print in the thumbnail was made by Thingiverse user BlondeEskimo. \nLet me know if you printed it!\nThanks! \nPrint Settings\nPrinter: Anycubic kossel plus\nRafts: Doesn't Matter\nSupports: Yes\nResolution: 0.2\nInfill: 10% or 20%\nNotes: 0.2 worked for me, but for finer quality you can also print at 0.1, but that was not tested! The supports are really needed!\nSomeone in the comments was talking about their print breaking apart while printing, so I'd advise to print at 30 mm/s, as 60 mm/s might be too fast.\nPrint took my printer about 2~3 hours\nIt would be nice if you could upload your makes to thingiverse!\nPost-Printing\nit's not necessary to do anything after it comes off the print bed, but sanding is never a bad idea, just watch out that you don't sand the rails too much on the inside because they might become too loose to hold onto the joy-cons