Nintendo Switch Grip (Docked)

cults3d

Obviously there's no shortage of 3D printable docked grips for the Switch, and while I could go on at length about my motivations and goals, let me just say that I'm quite particular when it comes to ergonomics and designed this as a complement to my portable switch grip found here. Trying to get straight to the point, what sets my design apart is mainly that it incorporates the proper metal rails from either the standard grip or the slide-on covers that come with the Switch. Additionally, it also incorporates the light pipes from the standard grip to make it all a bit more complete. On a similar note, the mid-section features a cut out intended for a laser-cut and engraved piece of acrylic in place of a logo. Recognizing that not everyone has access to a laser cutter or might not be comfortable disassembling their standard grip to get at the light pipes, I've included alternate versions of the Mid piece. In this case, there are versions that have the Switch logo incorporated into the design. Let me stress that I don't consider this finished, mainly in regards to the light pipes, and if you do decide to print that version then be prepared to put some extra work into it. Other than that, the design should print easily enough with the settings listed below.