Nintendo Switch, DS, and 3DS Cartridge Display Rack

thingiverse

***IMPORTANT*** I had to enable Brim and use the Cura Custom Support Plugin (see photo) to add a support block, and turn on support brim as well to print this without it falling over. You may be able to get away with using a raft, just make sure the part is securely attached to the raft, or it will tip. I haven't tried this myself. I created these quick display racks for use in my shop for displaying handheld games that don't have their cases. It works well for Switch, DS, and 3DS games and has a small ridge that keeps them from flipping back too easily. Use the "front lip" file if you're just printing one rack. If you want to make multiple rows of these, print the other file and attach it to the back of the "front lip" file with tape or glue. The rack is 165mm wide, the width of five DS games. I successfully printed these at .3mm layer height, 60mm/s though they were a bit stringy. I cleaned them up a bit because ideally, they're covered in games anyway!