Nintendo Switch Dock Wall Mount

thingiverse

I have a projector set up and most equipment hooked up to it is fairly out of reach, which hadn't been an issue so far since I would only infrequently reach up to change a disc. However, with the Switch needing to dock to charge and how often I switch between docked gameplay and handheld, it became quite bothersome. So I designed this mount to hold the dock onto a wall. It's held up by 3 screws that provide stability without taking up too much space. The design allows you to remove the dock without removing the mount if necessary, giving you more flexibility. There is room on both sides and in the back for proper venting to ensure the Switch stays cool during extended use. The mount seems to adequately hold the dock and Switch weight with no concern at all. With my design, you do lose the bottom side USB port and LED indicator, which were of no concern to me, so I made no effort to work around them. However, if there's enough interest, I suppose I could just snip part of that side out. But it would be easy to do on one's own as well. As a disclaimer, I am not an expert engineer, and although the print seems fine, I can't guarantee your Switch won't get scratched or fall suddenly. You use this at your own risk. I hope you enjoy using this mount. It has worked perfectly for me so far. Print Settings: Printer: Monoprice Maker Select v2 Rafts: Yes Supports: Yes Resolution: 0.2 Infill: 40% Notes: I'm sure the print setting can vary, but this is what worked for me in regards to a successful print and holding up the dock with zero issues so far. **WARNING: Be sure your middle screw does NOT protrude past the bumper around it otherwise you will LIKELY SCRATCH YOUR DOCK. I used a flat head screw for the job.** Post-Printing: I painted a Switch logo on the mount for added flair.