Nintendo Switch Dock (Nested USB) Remix

prusaprinters

I remixed Jackalopalen's Nested dock because it was the nicest, most compact one I've seen. I'm not interested in the springy dock, but the nested port is a great idea. (Here's mine on thingiverse)) Unfortunately for whatever reason the board in my dock was close but is clearly a different board. The holes didn't line up, it was a bit wider, etc etc. So I started out tweaking this one and have ended up with almost a complete re-draw of the top and bottom halves. Some of the changes: All posts removed. They kept snapping off, and ultimately they weren't needed to hold the board in place. I improved the strength of the USB-C out connector posts (the bits that hold the board and the USB-C mount in place) Widened a little to allow for the (slightly) larger board Changed the screw holes so now it will hold an M3 nut properly. Only need a short bolt for it. Little more support underneath the board. Widened the LED board holders as it was too tight a fit for mine Removed the hole for the LED and instead used a recess on the inside (I printed mine in a luminous blue to allow the LED to shine through) There was a LOT of minor tweaks to make the board fit. On TV I uploaded a couple different models, here I've only uploaded the ones with 2.5mm thick walls. It makes a difference. I've included the USB mount stl file however there have been no changes to this. If I find the photos of it again I'll upload them too. Print instructions20%, no supports required. Note you will need to disassemble your existing dock to get all the parts required to assemble this. Yes this will void your warranty on the dock. I'm not responsible for you breaking your dock if you go ahead and do this. Also, you'll need a male to female USB-C lead.