Nintendo Switch Comfort Grip (by jgr526) 3 PIECE V3 REMIX

thingiverse

Remix of the V3 grip so it has an independent LEFT, RIGHT, and MIDDLE piece. This version is specifically designed for users with small-sized beds, offering a middle split in two. A new variant called V3.5 was added, featuring notches on both the middle and grips to increase bonding surface area. However, these pieces must still be glued or bonded together. This remix is shared with permission from Jgr526 for users seeking a no-support, easy-to-print alternative to the original grip design. A successful print of white plastic using this remix is pictured above, printed at 0.21 layer height and 18% infill in ABS material. The middle piece was bonded to the grips using an acetone/ABS slurry mix, resulting in a firm hold with zero signs of weakness. Note that the grip pieces shown were printed and bonded without post-print sanding, which explains their slightly messy appearance. PLA or PETG materials can be used for printing this design, but it's recommended to use files with tabs for increased bonding surface area when using epoxy or glue.