Nintendo Switch 8x Cartridge Holder

thingiverse

I used Simplify 3D to slice this object. For this project, you'll need [4x 12x2mm neodymium magnets](https://www.amazon.com/gp/product/B07BK7SZD3/ref=ppx_yo_dt_b_asin_title_o06_s00?ie=UTF8&psc=1) to assist in holding the inserts in the cartridge container and keep them from falling out once opened. Simply use CA glue to attach the magnets into the cartridge holders. Print the Cartridge inserts horizontally and the Holder vertically, with no supports required if printing this way. The magnet at the bottom of the cartridge enclosure can be tricky to apply, but it's easily done with a little forethought. Hold the enclosure upside down (with the logo facing down), apply glue to the right side of the magnet, then slide the magnet into the enclosure (with the glue facing up). Next, slide a cartridge insert into the enclosure through slot #2 (the bottom slot or upper slot if you're holding it upside down) to pull the glued magnet into its desired hole. Let it rest for a few minutes while the glue sets. If this doesn't work, use a little CA glue solvent and try again. The bottom of the cartridge enclosure is wide open, waiting for your own initials or custom message. Add whatever you like! I hope you all enjoy this project as much as I have!