Nintendo Famicom controller cable clips

thingiverse

This is a cable clip for the Nintendo Famicom's controller cables, where they exit the rear of the console. I designed it because I had a Famicon without any clips, then sold it without them, so I haven't bothered to print these out. Still, I'm fairly certain they will work fine since I double-checked and triple-checked all measurements. The diameter of the hole for a cable is about 5mm; you'll need this when 3D printing. This clip is only half complete - print two of them to get a full one. I included the SketchUp file I made. I would have also included my hand-drawn diagrams on engineering paper, but I seem to have lost them. If you want to use this, but my license terms aren't suitable for you, just ask and I might change it for you.